Tools
4-1/2" x 7/8", 80 Grit Zirconia Flap Disc, Zirconia Grit Enables 3 Times Faster Material Removal Than Fiber Resin Metal Sanding Discs, The Abrasive Cloth Provides Up To 15 Times Longer Life, Fiberglass Backing Provides Optimal Grinding Angle Of 10 To 25 Degree.
150', Glo Orange, Flagging Tape, Weatherproof Poly Vinyl Chloride For Harsh Outdoor Conditions, Bright Fade Resistant Color Constructed Of Non Adhesive & Non Conductive Vinyl, 1-3/16" Wide, 3mm Thick.
150', Glo Lime, Flagging Tape, Bright Lime Weatherproof Poly Vinyl Chloride For Harsh Outdoor Conditions & High Visibility, Constructed Of Non Adhesive & Non Conductive Vinyl, 1-3/16" Wide, 3mm Thick.
3/16", 80 Grit Flapwheel, For Grinding & Polishing Flat Or Contoured Surfaces On Metal, Wood, Rubber Or Plastic, As Flaps Wear Down New Abrasive Is Exposed.
1/8" High Speed Steel, Corner Rounding Router Bit, For Routing, Inlaying & Mortising In Wood & Other Soft Materials.
5/64" Diamond Wheel Point, Diamond Particle Covered Bit, For Detail Work, Cutting, Engraving, Carving, Touch Up & Finishing, Use On Wood, Jade, Ceramic, Glass, Hardened Steel, Semi-Precious Stones & Other Hard Materials, New 1/8" Shank.
Diamond Wheel Point Set, Contains #7103 & #7144 Diamond Wheel Points, Diamond Particle Covered Bits, For Detail Work, Cutting, Engraving, Carving, Touch Up & Finishing, Use On Wood, Jade, Ceramic, Glass, Hardened Steel, Semi Precious Stones & Other Hard Materials, New 1/8" Shank.
OZ, Vial For Cleaning & Polishing Metals & Plastics, Use Polishing Compound With Buffing Wheels To Produce A High Luster.
Tungsten Carbide Cutter, 1/8" Diameter With 1/8" Shank, Carbide Is The Next Hardest Material To Diamonds, Used For Shaping, Smoothing & Material Removal, Use On Hardened Steel, Stainless Steel, Cast Iron, Non Ferrous Metals, Fired Ceramics, Plastics, Hardwoods & Other Hard Materials, Do Not Run In Excess Of 35,000 RPM.
Tungsten Carbide Cutter, 1/8" Diameter With 1/8" Shank, Carbide Is The Next Hardest Material To Diamonds, Used For Shaping, Smoothing & Material Removal, Use On Hardened Steel, Stainless Steel, Cast Iron, Non Ferrous Metals, Fired Ceramics, Plastics, Hardwoods & Other Hard Materials, Do Not Run In Excess Of 35,000 RPM.
Carbon Motor Brush, Fits Master Mechanic Models: MM3750, MM375 & MM3950 Type 3, 4 & 5, Also Fits Moto-Tools #'s 275, 285, 395, 410 & 595, Type 3, 4, 5 & 6.
24", Fatmax, Yellow Powder Coated Paint, Bar, Extra Wide Handle For Increased Strength & Leverage, Separate Slot For Pulling Nails.